Блинкер

[Zukas]

Добрый день!
Подскажите, можно ли установить готовый автомобильный блинкер на мотоцикл и как его правильно подключить?
Нужна только лампа без тахометра, и чтобы срабатывала на 8000 оборотов где то...
Вариант 1


Вариант 2


Или как другой вариант установить тахометр со вспышкой.


Вариант 1


Вариант 2


 

[Крокодил]

http://vmax-club.ru/forum/index.php?topic=10195.0

[Крокодил]

http://vmax-club.ru/forum/index.php?topic=3438.0

[валера ник]

 вот поставил..работает всё супер.. http://moto.kiev.ua/trid/moto/125832749616/259

[Zukas]

вот поставил..работает всё супер.. http://moto.kiev.ua/trid/moto/125832749616/259

Мне только лампа нужна. Тахометром не хочу портить оригинальный вид...

[ALEXX]

Возможно, кому-нибудь пригодится.
Установка шифт лайта на макса:

http://www.raptorperformance.com/pages/raptor-shift-light-install-yamaha

Raptor Shift Light Install-Yamaha VMAX:

Everything needed to connect the Raptor rev light is located on the back of the existing, on-board tachometer.

1. Remove the seat.
2. Disconnect the negative terminal on the battery. - Important!
3. Remove the top cover.
4. Remove the air filter case cover.
5. Remove the air filter.
6. Take time to protect the carburetor intakes. - Important!
7. Look under the existing instrument panel and unscrew the two mounting bolts.
8. Turn the instrument panel over and unbolt the mounting bracket from the instrument panel (two nuts). You are trying to access the back of the existing tachometer.
9. Place your inline fuse on the red wire. - Important
10. On the back of the existing tachometer you have three terminals. On the 2004 models the black is your needed ground wire. The Gray/yellow is your needed tach wire, and the brown is your needed switched 12 volts connection. Take time to make sure none of the wires are touching each other after you are done with your connections.



11.Set the light for 2 cylinder mode
12. Before you start back out, you can test your work for the most part, by simply connecting the ground terminal and turning the ignition key to the "on" position. It should perform exactly as the instructions say it will. You might want to determine how many flashes you can expect ahead of may time to be ready for that.
13. Once that has been accomplished, you back out in inverse order of the way you came in, with the exception of the negative battery cable.
 
****For Dual Mode Shift Light Install, see below****
Connect the white wire of the shift light to the green wire with white stripe, coming from the turn signal cancelling module located under the left faux air scoop. (With ignition on, this wire has a pulsating voltage when the front wheel is turning due to a reed resistor in the speedo cable housing; no pulse when sitting still.)


ссылка на шифтлайты
http://www.raptorperformance.com/collections/shift-lights


 (с) www.raptorperformance.com